Alarm.Com Building 36 ADC-T3000 Manual page 2

Thermostat Z-Wave Specification
1 Z-Wave Add and Remove Process
To navigate the menus, use up/down buttons to move selection and the selection (>) button to
confirm the selection.
1.1 Adding the thermostat to a Z-Wave network
1. Put Z-Wave controller into Add mode. See Z-Wave controller documentation for further
documentation.
2. Press the Menu (-) Button
3. Select SETTINGS
4. Select NETWORK
5. Select ADD
6. Thermostat will display 'Network Add In Progress' and the 5-digit DSK pin. The pin can
be used for S2 inclusion.
7. The thermostat has been added successfully when the thermostat displays 'Network
Add Complete'
1.2 Removing the thermostat from a Z-Wave network
8. Put Z-Wave controller into Remove mode. See Z-Wave controller documentation for
further documentation.
9. Press the Menu (-) Button
10. Select SETTINGS
11. Select NETWORK
12. Select REMOVE
13. Thermostat will display 'Network Remove In Progress'.
14. The thermostat has been removed successfully when the thermostat displays 'Network
Remove Complete'
Building 36 Technologies
An Alarm.com Company
June 26, 2019
2