Alarm.Com Building 36 ADC-T3000 Manual page 13

Thermostat Z-Wave Specification
5.1.38 0x26 : Z-Wave Association Report Bit Mask
• Bitmask to selectively enable non-required Z-Wave association reports. The report is
enabled if the bit is set to one (1).
o Bit 0 – Thermostat Mode
o Bit 1 , 2– Reserved
o Bit 3 – Thermostat Operating State
o Bit 4 – Thermostat Fan Mode
o Bit 5 – Thermostat Fan State
o Bit 6 – Ambient Temperature
o Bit 7 – Relative Humidity
o Bit 8 – Reserved
o Bit 9 – Battery Low Notification
o Bit 10 – Battery Very Low Notification
o Bit 11- Thermostat Supported Modes
o Bit 12 – Remote Enable Report
o Bit 13 – Humidity Control Operating State Report
o Bit 14 – HVAC Type
o Bit 15 – Number of Cool/Pump Stages
o Bit 16 – Number of Heat/Aux Stages
o Bit 17 – Relay Status
o Bit 18 – Power Source (C-Wire or Battery)
o Bit 19 – Notification Report Power Applied
o Bit 20 – Notification Report Mains Disconnected
o Bit 21 – Notification Report Mains Reconnected
o Bit 22 – Notification Report Replace Battery Soon
o Bit 23 – Notification Report Replace Battery Now
o Bit 24 – Notification Report System Hardware Failure
o Bit 25 – Notification Report System Software Failure
o Bit 26 – Notification Report System Hardware Failure with Code
o Bit 27 – Notification Report System Software Failure with Code
o Bit 28 – Display units (C/F)
o Bit 29 – Heat Fuel Type
o Bit 30 – Humidity Control Mode
o Bit 31 – Humidity Control Setpoints
• Default is 0xFFFFFFFF
• Size 4 byte
Building 36 Technologies
An Alarm.com Company
June 26, 2019
13