Alarm.Com ADC-T2000 User Manual
  1. Manuals
  2. Brands
  3. Alarm.Com Manuals
  4. Thermostat
  5. ADC-T2000
  6. User manual

Alarm.Com ADC-T2000 User Manual

Smart thermostat
Hide thumbs Also See for ADC-T2000:

Advertisement

Table of Contents

Smart Thermostat
User Guide
ADC-T2000

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ADC-T2000 and is the answer not in the manual?

Questions and answers

Related Manuals for Alarm.Com ADC-T2000

Summary of Contents for Alarm.Com ADC-T2000

  • Page 1 Smart Thermostat User Guide ADC-T2000...

  • Page 2: Installation Precautions

    Questions? • You must follow all local codes and ordinances for wiring the system. Visit answers.alarm.com • This thermostat should only be powered by or contact your service provider. 4 AA alkaline batteries or a listed Class 2 power supply at 24 VAC (C-Wire or wall transformer).

  • Page 3: Thermostat Overview

    In the box Thermostat overview Buttons Display UP: Adjust target temperature up. HEAT: Illuminated in HEAT, EMER or AUTO mode. MODE: Change thermostat between HEAT, COOL, AUTO, EMER COOL: Illuminated in COOL and OFF modes. or AUTO mode. Thermostat Back plate Trim plate DOWN: Adjust target temperature.
  • Page 4 Location Preparation Test the system Remove the thermostat cover If replacing an old thermostat, the new • Be aware of what is on the other side thermostat can be mounted in its place. of the wall where the thermostat is If a new location is desired it will be being installed.

  • Page 5: Installation

    Prepare the wires Install the back plate Installation Disconnect all of the wires and remove the Use the bubble level provided on the back plate existing thermostat. Remember to secure as a guide. Mark where the screws will go with Wire your new thermostat the wires so they don’t fall into the wall.
  • Page 6 Terminal designations Install the batteries The thermostat can be powered by battery • If the home is unoccupied for a month or Conventional system Heat pump or 24 VAC. If a wall transformer is used to more, such as with vacation homes, you power the thermostat, connect between should replace the batteries as a preventive Terminal...
  • Page 7 Attach the body and back plate Turn the power on Connect to the system ❶ Verify that any excess wire is tucked back into Restore power to all the heating and Put the thermostat in OFF mode the wall to allow room for the thermostat to sit cooling systems.

  • Page 8: Configure The System

    Configure the system Configuration System Type Description/Note Normal electric heating system, thermostat Manual configuration of HVAC system The thermostat configuration will be done on Normal 2-heat 2-cool system NORM turns on fan with heat. Two or fewer stages on thermostat your online account.

  • Page 9: Operation

    Operation Changing the mode and set point Changing the batteries • In AUTO, the brighter icon will indicate which set point is currently displayed ❶ Press the UP/DOWN buttons and active HEAT or COOL If the thermostat batteries are low, replace once to display the current set point.

  • Page 10: Troubleshooting

    Troubleshooting Heating or cooling doesn’t turn on when Exclude the thermostat from the Batteries drain quickly the set point is above or below the Z-Wave network room temperature If a thermostat is included using a “C” Wire, If for some reason the thermostat must be that information is saved in the network and To prevent damaging the compressor, excluded from the network, follow the...
  • Page 11 Notices • Consult the dealer or an experienced radio/TV This device complies with part 15 of the FCC Rules. Operation technician for help. is subject to the following two conditions: This device may not cause harmful interference. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum This device must accept any interference received, including (or lesser) gain approved for the transmitter by...
  • Page 12 Notes...
  • Page 13 8281 Greensboro Drive 200731 Suite 100 © 2020 Alarm.com. All rights reserved. Tysons, VA 22102 Designed, developed and assembled in the USA.

Table of Contents

Save PDF