Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Alarm.Com ADC-T2000-RC
Summary of Contents for Alarm.Com ADC-T2000-RC
- Page 1 ADC-T 2000 ADC-T2000 Smart Thermostat User Guide Product Manual 170308 v1.5...
- Page 2 Smart Thermostat Product Manual | 1 • Before installing or servicing the thermostat, turn • This thermostat should only be powered by off power to the system at the circuit breaker. 4 AA alkaline batteries or a listed class 2 power supply at 24 VAC (C-Wire or wall transformer).
-
Page 3: Box Contents
2 | Smart Thermostat Product Manual Smart Thermostat Product Manual | 3 BOX CONTENTS THERMOSTAT OVERVIEW MODE DOWN DISPLAY HEAT COOL Thermostat Backplate Trim Plate (Optional) RADIO Buttons • UP - Adjust target temperature up. • EMER - For use with heat pumps only. Will bypass the heat pump and enable the •... - Page 4 4 | Smart Thermostat Product Manual Smart Thermostat Product Manual | 5 LOCATION PREPARATION If replacing an old thermostat, • Mount thermostat on an • Be aware of what is on the The Existing Thermostat the new thermostat can be inside wall, approximately other side of the wall where 1.
-
Page 5: Install Your New Thermostat
6 | Smart Thermostat Product Manual Smart Thermostat Product Manual | 7 INSTALL YOUR NEW THERMOSTAT TIP: Take another picture of the wires to • Disconnect all of the wires and remove the Install the Back Plate Wire Your New Thermostat •... - Page 6 8 | Smart Thermostat Product Manual Smart Thermostat Product Manual | 9 Insert Batteries Into the Thermostat • Always replace the batteries at least once a year. This will protect the thermostat from damage and corrosion by leaking batteries. • If the home is unoccupied for a month or more, such as vacation homes, you should replace the batteries as a preventive measure against battery failure while you are away.
-
Page 7: Configure The System
Minimum Set Points and Thermostat Lock. 4. After verifying the heating system is working, Alarm.com system, or contact an Alarm.com return the set point to the desired temperature. 2. Put the Z-Wave controller into inclusion mode. -
Page 8: Operation
12 | Smart Thermostat Product Manual Smart Thermostat Product Manual | 13 OPERATION Manual Configuration of HVAC System 3. Press and hold the UP button again for 5. Press the MODE button at any time to on Thermostat 5 seconds until the display shows your change the mode. -
Page 9: Troubleshooting
Try switching the O/B configuration setting through your online For more help, contact your account. Contact a local HVAC professional for Alarm.com Service Provider. further help with this issue. - Page 10 16 | Smart Thermostat Product Manual NOTICES This device complies with part 15 of the FCC Rules. Operation is Under Industry Canada regulations, this radio transmitter may subject to the following two conditions: only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada.
- Page 11 © 2017 Alarm.com. All rights reserved.
Need help?
Do you have a question about the ADC-T2000-RC and is the answer not in the manual?
Questions and answers