Assembly
Your mill comes from the factory mostly assembled.
To complete assembly you must install:
•
X-Axis handwheel handles
•
Y-Axis handwheel handle
•
Z-Axis crank
•
Coarse downfeed handle
•
Fine downfeed handwheel handle
Tools Needed
Open-End Wrench 14, 19mm ...................... 1 Ea.
Flathead Screwdriver ..........................................1
To assemble mill:
1.
Install handwheel handles onto X-axis and
Y-axis handwheels (see Figure 15).
X-Axis
Handwheel
Y-Axis
Handwheel
Figure 15. Locations of X-axis and Y-axis
handwheels.
2.
Slide Z-axis crank onto square spindle (see
Figure 16).
Figure 16. Location of square spindle.
-22-
3.
4.
Qty
Downfeed Hub
Figure 17. Downfeed components assembeled.
Square
Spindle
Thread coarse downfeed handle into coarse
downfeed hub (see Figure 17).
Remove fine downfeed handle from rear of
fine downfeed handwheel and thread into
front of handwheel (see Figure 17).
Fine
Downfeed
Handwheel
Coarse
Model G0757Z (Mfd. Since 02/15)