Table of Contents
Advertisement
SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual and seek additional training from expe-
rienced machine operators, and do additional
research outside of this manual by reading "how-
to" books, trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire
using machine.
To reduce risk of eye or face injury from
flying chips, always wear approved safety
glasses and a face shield when operating
this machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
Model G0757Z (Mfd. Since 02/15)
manual
BEFORE
To complete a typical operation, the operator
does the following:
1.
Examines workpiece to make sure it is suit-
able for operation.
2.
Firmly clamps workpiece to table or a mill
vise.
3.
Installs correct cutting tool for operation.
4.
Uses downfeed and table controls to cor-
rectly position cutting tool and workpiece for
operation. If X-axis power feed will be used
during operation, operator confirms speed
and length of table movement required.
5.
Configures machine for correct spindle speed
of operation.
6.
Puts on personal protective gear, and makes
sure workpiece and table are clear of all
tools, cords, and other items.
7.
Turns machine ON, then starts spindle rota-
tion and performs operation.
8.
Turns machine OFF.
-27-
Advertisement
Table of Contents
