Door Features; Condiment Bins; Fresh Bin; Half-Height Bin - Kenmore 106.4673 Use & Care Manual

DOOR FEATURES

NOTE: Your model may have some or all of these features.

Condiment Bins

To remove and replace the condiment bins:
1. Tilt the bin by pulling it outward.
2. Remove the bin by lifting it upward off the glides.
3. Replace the bin by sliding it back onto the glides and then push
it closed.

Fresh Bin

(on some models)
To remove and replace the fresh bin:
1. Open the bin by grasping the top center lip of the bin and
tilting the bin outward.
2. Remove the bin by grasping both sides of the bin and lifting the
bin upward off the glides.
3. Replace the bin by sliding it back into its tilted position on the
glides and then push it closed.
Ice Storage Bin
1. Wash the ice storage bin with mild soap and warm water.
2. Slide the ice storage bin under the ice maker, and push it
toward the back as far as it will go.
3. Lower the arm on the ice maker to the ON position.
NOTE: It usually takes approximately 24 hours for the ice
maker to begin producing ice. You may notice the ice has
an "off-taste." If so, discard the first three batches of ice
produced. After that the "off-taste" should be gone.
18
Ice Production Rate
1. The ice maker should produce approximately 8 to 12 batches
of ice in a 24-hour period. Allow 3 days to completely fill the
ice container.
2. To increase ice production, lower the freezer and refrigerator
temperature. See "Using the Controls." Wait 24 hours between
adjustments.

Half-Height Bin

(on some models)
To remove and replace the half-height bin:
1. Tilt the bin by pulling it outward.
2. Remove the bin by lifting it upward off the glides.
3. Replace the bin by sliding it back onto the glides and then push
it closed.

Ice Maker

IMPORTANT: For models with a water filter, after connecting the
refrigerator to a water source or replacing the water filter, fill and
discard three full containers of ice to prepare the water filter for
use.
Turning the Ice Maker On/Off
To turn ON the ice maker, simply lower the wire shutoff arm.
To manually turn OFF the ice maker, lift the wire shutoff arm to the
OFF (arm up) position and listen for the click.
NOTE: Your ice maker has an automatic shutoff. As ice is made,
the ice cubes will fill the ice storage bin and the ice cubes will raise
the wire shutoff arm to the OFF (arm up) position. Do not force the
wire shutoff arm up or down.