Table of Contents
Advertisement
OPERATION INSTRUCTIONS
THERMOSTAT HOOK-UP
The Jumper Must
Be Removed First
1. Put female terminals on the lead wires to
your low voltage thermostat.
2. Plug one thermostat lead onto each of the
terminal posts on the circuit board.
IMPORTANT NOTE:
The purpose of the T'Stat is
to
make
the
stove
preselected desired heat range setting ("1" to
"5") and the minimum heat range setting of "1".
The T'Stat will not turn the stove on and off.
When the desired room temperature has been
reached and the T'Stat no longer requires heat
it will reduce to a minimum heat range setting of
"1". The unit will not turn completely off. Once
the room temperature has dropped and the
T'Stat requires more heat, the unit will begin to
feed pellets at the preselected heat setting
ranging from "1" to "5".
Use 18 gauge, 2
conductor wire
11
© 2021 United States Stove Company
cycle
between
the
Advertisement
Table of Contents
