Machine Setup - American Sanders Legend Operator's Manual

EN
To set-up your machine, follow this procedure:
1. Familiarize yourself with the machine and read all danger,
warning and caution statements. Make sure all operators of this
machine have read this Operator's Manual. If they cannot read
this manual, have the manual explained fully before allowing
anyone to operate the sander.
2. Locate the electrical source. The receptacle should be
compatible with the plug. The receptacle must be grounded and
must be fused (see nameplate for electrical requirements) to
avoid an electrical hazard.
3. Make sure the ring on the dust bag is flipped open. (See figure 14)
4. Slide the opening onto the dust tube until it touches the flange,
orienting the pin into the locating hole on the dust tube flange.
(See figure 15)
5. Flip the ring around tab in the dust tube to lock into place.
(See figure 16)
6. Wind the power cord through the cable arm. (see figure 17)
Keep the power cord out of the path of the machine.
DO NOT connect the power cord to the motor at this time.
7. Open the sanding belt access door by lifting the quick release
lever. The door will spring open. (See figure 18)
8. Rotate the sanding belt release lever forward (See figure 19)
Damage to the sanding drum will occur if the
CAUTION:
machine is operated without a sanding belt.
9. Install a new sanding belt by sliding the belt over the tension
roller and drum. (See figure 20)
10. Rotate the sanding belt release lever backward to tighten the
sanding belt.
Do not force the release lever. Doing so can
CAUTION:
damage the tracking mechanism and cause the sanding belt
to mis-track.
11. Connect the handle pigtail to the motor. (See figure 9)
12. Connect the power cord to the motor pigtail. The connection must
be twisted clockwise to lock. (See figure 21)
NOTE: Ensure the breaker on the control panel is in the ON position.
13. Turn the control switch (See figure 22) on momentarily while
observing the belt tracking. Follow the procedures outlined in the
"Sander Adjustment Procedures" section on page 14 to correct
the belt tracking. There is also a label on the inside of the access
door that outlines the belt adjustment.
14. Close the access door.

Machine Setup

Figure 14
10
Figure 15
Figure 16
Figure 17
Figure 17
Figure 18