Sander Adjustment Procedures - American Sanders Legend Operator's Manual

EN
Electrocution could occur if maintenance and
DANGER:
repairs are performed on a unit that is not properly dis
connected from the power source. Disconnect the power
supply before attempting any maintenance or service.
Moving parts of this machine can cause serious
DANGER:
injury and/or damage. Keep hands, feet and loose
clothing away from all moving parts of the sander.
The following information provides details on how to adjust different
features/controls of the sander.
Dust Shoe
To adjust the dust shoe follow this procedure:
1. Disconnect machine from power supply.
2. Loosen the three screws fastening the dust shoe to chassis.
3. Adjust the dust shoe down to reduce clearance.
4. Adjust the dust shoe up the increase clearance.
5. Align the dust shoe to the chassis and tighten screws.
(See figure 36)
Laser Adjustment
1. Plug machine into power cord.
2. Remove protective cap from end of laser.
Note: Ensure the circuit breaker is in the ON position.
CAUTION: Laser Radiation- Do Not Stare into Beam.
Class 2 laser product.
3. Loosen the set screw on the side of the laser holder.
(See figure 37A)
Note: Make sure the floor is level before adjusting laser line.
4. Line up the laser with a seam in the floor. (See figure 37B)
5. Using a combination square placed against the wall, twist the
laser until it lines up with the edge of the square. (See figure 37C)
6. Tighten the set screw on the side of the laser holder.
Sanding Pressure
There are 5 pressure settings (1-5). Level 1 is the lowest pressure with
level 5 being the highest pressure. To change the setting, raise or lower
the lever and place in desired position. (See figure 38)

Sander Adjustment Procedures

15
Figure 36
Figure 37A
Figure 37B
Figure 37C
Figure 38