Advertisement
chronograph will be needed to achieve desired velocity.
Re-Installation of Main Spring, Bolt and Bolt Guide Assembly
• Slide the Main Spring onto Bolt, and then the Bolt onto Bolt Guide, so it
is one assembly. You will notice, one end of the spring is smaller and will
lock onto the bolt.
• Insert Bolt Assembly
back into the body.
• Line up the alignment
hole on the guide with the alignment pin on the body and slide the bolt
assembly fully forward to the body.
• Holding the bolt assembly tight into the back of the body with one hand,
reinstall the Bolt Guide retention screw and tighten using the 1/8" Allen key.
Circuit Board Removal
The Circuit Board should only need to be removed to clean the break beam eyes.
• Remove the Body Assembly from the shell.
• Using a 5/64" Allen key, remove the two Circuit Board screws and
gently remove the Circuit Board.
Wiring Harness Removal
Note: The wiring harness should only need to
be removed if you are washing the right shell
of the TM-7.
• Carefully pull the 2 battery spring tabs out of
the right side shell, using needle nose pliers.
Be careful not to break the wires from the bat-
tery tabs.
• Then lift the wiring harness guide OFF,
and remove harness.
Re-Installation of Wiring Harness
Make sure the wire harness is routed
through the circuit board and along the
body above the circuit board as shown
and not through the trigger area. Failure
to route the wires properly will result in
destruction of the wires during re-installation of the shell, and can result
in an electrical fire when the battery is installed. Destruction of the wire
harness is not covered under warranty.
Regulator Hex Adjustment
The Regulator has 2 Hex spacers which hold the shell together and the grips
on. If they need adjusting, simply insert an Allen key and push it thru the
shell and hex. This will align the hex spacers and the screw will go in easily.
15. Storage and Transportation
IMPORTANT: Never carry your TM-7 uncased when not on a playing field.
The non-playing public and law enforcement personnel may not be able
to distinguish between a paintball marker and firearm. For your own
safety and to protect the image of the sport, always carry your TM-7 in a
suitable marker case or in the box in which it was shipped.
• Your TM-7 must be clear of all paint and propellant when not being used.
• Make sure the TM-7 marker is OFF. Push the Power button and hold for
2 seconds until the LED light changes from Red to Green.
• Put the barrel blocking device in its place. Make sure the marker is clean.
• Store your TM-7 in a clean, cool, dry place.
B T P A I N T B A L L . C O M
13
Advertisement
