Reassembly/ Storage And Transportation - BT DELTA ELITE Operator's Manual

ASA Removal
1. Remove the 2 screws which go thru the ASA with a 1/8" allen wrench.
Stock Removal
(See body disassembly instructions )
Body disassembly (Internal components)
To fully access the internal components, these parts must be removed first:
- Barrel assembly
- Rip-Clip and loader
- Sight rails
- Magazine assembly
- Grip frame
Receiver (Body) Separation
Make sure the marker is in the un-cocked (forward position) before taking body
apart.
1. Remove the Cocking Handle Cover (rubber bonnet).
2. Lay on a flat surface with the name plate facing up.
3. Remove the four upper receiver retention screws.
4. Lift name plate receiver away from other receiver half.
Note: The stock will be under some spring tension and may spring out when the top
name plate receiver is lifted off.
Note: The retention screw located below the cocking handle slot is longer than the
rest.
Hammer, Cocking Handle and
Connecting Rod Removal
1. Rotate Hammer counter-clock-
wise.
2. Remove Connecting Rod.
3. Remove Cocking Handle.
4. Slide Hammer rearward and
remove.
6
Barrel Adapter, Ball Retainer and Bolt Removal
1. Lift away Barrel Adapter (and barrel if still installed).
2. Lift out Ball Retainer.
3. Slide Bolt forward and remove

Reassembly/ Storage and Transportation

Reassembly
To reassemble the marker, reverse the Disassembly instructions starting with the
barrel adapter, ball retainer and bolt removal. While reassembling the marker, you
should oil all O-rings and sliding parts. All parts and o-rings returned to the marker
should be free of debris and visual nicks and scratches which can alter the perform-
ance of the marker. All screws returned to the marker must be tightened so there is
no chance of them vibrating loose.
Stock Removal
Once the body is
Storage and Transportation
separated, simply
1. BT Delta must be clear of all paint and propellant when not being used.
lift the stock from
2. Be sure to have marker in "SAFE MODE" when not in use.
the body. Be care-
3. Make sure barrel blocking devise is in place.
ful not to lose any
4. Store BT Delta™ and propellant in cool dry place.
of the rear parts
5. Keep your BT Delta™ away from children without proper supervision.
when removing
6. Your BT Delta™ must be free of all paint and not attached to a propellant source
the stock.
while being transported to and from the playing field.
7. Observe and obey all local, state and federal laws concerning the transportation
of paintball markers. For information concerning any of the laws in your area, con-
tact your local law enforcement.