Advertisement
To turn the eyes OFF, ensure that there are no paintballs in the TM-7
breech or feed elbow, make sure the marker is switched OFF, and while
pulling and holding the trigger, turn the marker ON. A quick double blink-
ing Green LED will indicate that the eye system has been deactivated.
To turn the eyes back ON, simply tap the power button one time quickly.
Notes:
• A slow consistent single flashing Green LED indicates that the eyes are
ON with no ball in the breech and a rapid flashing Green LED indicates
that there is a ball in the breech.
• For optimal performance of the TM-7 eyes, keep the inside of the TM-7
breech clean and clear of broken paint, paint residue, or other debris.
• Although the eyes can be cleaned via cleaning the breech of the TM-7
marker, if the eyes need to be accessed please follow the steps outlined
in the Disassembly/ Assembly section of this manual.
8. Unloading the TM-7
Always keep your TM-7 pointed in a safe direction and always keep your
protective eye, face and ear wear on until marker is completely unloaded.
• Be sure your finger is away from the trigger area.
• Place the barrel plug, sock, or barrel blocking device into the end of the barrel.
• Move the Selector switch to the safety position (0).
• Turn the TM-7 OFF by pressing and holding the Power button. The LED
will turn from RED to GREEN. Observe the light to make sure it is no
longer lit.
• Remove your pressurized gas source by slowly and carefully unscrewing it.
• If you are using an electronic loader make sure loader is completely
turned OFF.
• Slightly tilt the marker so that the loader is lower than the body.
• Remove the loader by spinning it in a clockwise direction and gently
pulling it.
• Read the pressure gauge and make sure the pressure reads 0 PSI.
• DO NOT look down the barrel but look down the feed neck to make
sure there are no paintballs in the breech.
•Remove the barrel from the marker.
• Make sure there are no more paintballs remaining in the barrel.
Note: Always keep your TM-7 pointed in a safe direction!
9. TM-7 Regulator and Velocity Adjustment
The TM-7 utilizes a fully functional TM-7 Bottom-line Regulator at the bot-
tom of the grip frame that doubles as an ASA Adapter/Receiver for a
standard threaded pre-set output compressed air systems. This unique
regulator system channels air through the air transfer tube, eliminating
the need for external macro line and fittings. The TM-7 Bottom-line
Regulator controls the amount of air pressure going from your com-
pressed air system into the maker itself.
The TM-7 regulator should be factory pre-set at 200 PSI as this is the best
operating pressure for firing the marker. However, if over time you do
need to adjust the pressure only use the Regulator Adjuster Screw on the
front of your TM-7 Bottom-line Regulator.
B T P A I N T B A L L . C O M
5
Advertisement
