Advertisement
5. Basic Operation
Safety and safe marker handling are the most important aspects of paint-
ball sports. Please practice each of the following steps with an unloaded
marker before attempting to charge your marker with compressed air
and paintballs.
• Do not install compressed air or load paintballs into your TM-7 until you
feel completely confident with your ability to handle your TM-7 safely.
• Keep your finger out of the trigger guard and away from the trigger;
point the muzzle of the marker in a safe direction at all times. Keep the
marker turned OFF until ready to operate. The TM-7 uses an ON/OFF
switch and a selector switch for its safety devices.
• Always keep your TM-7 pointed in a safe direction. Always use a barrel
plug or barrel blocking device. Always use ASTM approved paintball
specific eye protection in any areas where paintball markers may be dis-
charged. Remember that the ultimate safety device is you, the operator.
Barrel Installation
Make sure marker is degassed, hopper removed, no paintballs in the feed
elbow or breech and the TM-7 is turned off.
• While pointing marker in a safe direction, place the threaded end of the
barrel into the front opening of the marker body.
• Turn the barrel clockwise until it stops (do not over tighten).
• Install a barrel blocking device. This can be a barrel plug or other such
device that prevents the accidental discharge of a paintball.
Switching On your TM-7
To switch the TM-7 ON, set the Selector Switch to the Safety position.
Locate the Power Button on the left side of the marker. Push and hold the
button for 2 seconds and the LED light will turn Green and then to Red.
Release button and the LED
will remain RED.
The TM-7 will now be ON and
in the Safety Position. To make
the TM-7 Live, move the
Selector Switch to the desired
Firing Mode.
Switching OFF your TM-7
Move the Selector Switch to the Safety Position, push and hold the Power
Button for 2 seconds and the LED will turn from Red to Green. Release
button and the TM-7 will switch OFF.
Selector Switch
The TM-7 comes equipped with a 4 position Selector switch. The TM-7
comes factory set in the recreational firing mode setting. Simply move the
selector from Position (0) Safety, to Positions (1-3) to change to a Firing Mode.
Selector Positions
0 = Safety ------------------------
1 = Semi Auto ---------------
2 = 3 NXL Full Auto -----
3 = PSP Burst ------------------
Automatic OFF feature
The TM-7 also has an "Automatic OFF" feature. If you accidentally leave
your TM-7 powered up, it will shut itself OFF after approximately 1 hour
of inactivity.
B T P A I N T B A L L . C O M
3
Advertisement
