BT DELTA ELITE Operator's Manual
  1. Manuals
  2. Brands
  3. BT Manuals
  4. Paintball equipment
  5. DELTA ELITE
  6. Operator's manual

BT DELTA ELITE Operator's Manual

Hide thumbs

Advertisement

Table of Contents

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DELTA ELITE and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for BT DELTA ELITE

Summary of Contents for BT DELTA ELITE

  • Page 2: Table Of Contents

    1. Rules for Safe Marker Handling ....1 2. Included with your BT Delta Elite™ ....1 3.

  • Page 4: Rules For Safe Marker Handling

    * READ OWNERS MANUAL BEFORE USING.* Rules of Safe Marker Handling Included with your BT Delta Elite 1. Treat every marker as if it were loaded. 1. BT-Delta Elite™ with Electronic Grip 2. Never look down the barrel of a paintball marker.

  • Page 5: Introduction And Specifications

    3. While pointing the marker in a safe direction, remove the barrel blocking device. balls in the feed port 4. Point the BT Delta Elite™ over a chronograph that will measure the velocity of the or breech and the E- paintballs discharged by the marker.

  • Page 6: Rip Clip

    1. Loosen up the spring screws. (Figure 2) 3. The LED will only stay red for about 15 seconds, then change back to its flashing 2. Clip on the BT Delta Elite™ between the 2 sight rails. green sequence for regular operation if no buttons are pressed.

  • Page 7: Apex™ Barrel

    Construction: Nylon modes are changed by removing the left side grip and adjusting the dip switches Features: located in the grip frame. The Delta Elite Auto-Off 1 Hour comes in Ramping mode from the factory Low Battery Indicator and the Jumper in the frame must be...

  • Page 8: General Maintenance

    Body Sight Rails Removal Once the BT Delta is unloaded and the air cylinder is removed, you can use a damp 1. Remove the Rip cloth to wipe off paint, oil, dirt and debris. You can also use warm water to rinse the Clip and Barrel marker clean, but be careful not to get the internal components wet.

  • Page 9: Reassembly/ Storage And Transportation

    5. Keep your BT Delta™ away from children without proper supervision. when removing 6. Your BT Delta™ must be free of all paint and not attached to a propellant source the stock. while being transported to and from the playing field.

  • Page 10: Troubleshooting

    Troubleshooting PROBLEM PROBLEM DIAGNOSIS DIAGNOSIS SOLUTION SOLUTION Marker double firing or going full auto • Air cylinder low on air • Get air cylinder filled • Rear bolt oring worn or damaged • Replace rear bolt oring • Rear bolt or sear worn •...

  • Page 11: Parts List

    Parts List BT4 = BT-4 Parts (all models apply) • BTE = Elite Parts (other models my apply) • BTRC = Rip Clip Parts • BTEG = E-Grip Parts • BTA = Apex Parts DESCRIPTION PART # DIAGRAM # DESCRIPTION...
  • Page 12 MAGAZINE HOLDER BODY SCREW BTE-40 M-40 CAPACITOR FOAM BTEG-23 G-23 MAGAZINE HOLDER NUT BTE-41 M-41 RELEASE MECHANISM SCREW BTE-42 M-42 BT ELITE- PARTS STOCK FRONT BTE-43 S-43 BARREL SIGHT BODY BTE-1 STOCK BODY BTE-44 S-44 LEFT SIGHT RAIL HALF BTE-2 RIGHT STOCK ARM...

  • Page 15: Warranty Information

    There are no other warranties or guarantees, expressed or implied, made by BT PAINTBALL DESIGNS, INC. on this marker. The sole and exclu- sive liability of BT PAINTBALL DESIGNS, INC.

Table of Contents