Legal Information About this Manual The Manual includes instructions for using and managing the Product. Pictures, charts, images and all other information hereinafter are for description and explanation only. The information contained in the Manual is subject to change, without notice, due to firmware updates or other reasons. Please find the latest version of this Manual at the company website Please use this Manual with the guidance and assistance of professionals trained in supporting the Product.
Page 3
NUCLEAR FUEL-CYCLE, OR IN SUPPORT OF HUMAN RIGHTS ABUSES. IN THE EVENT OF ANY CONFLICTS BETWEEN THIS MANUAL AND THE APPLICABLE LAW, THE LATER PREVAILS.
Regulatory Information FCC Information Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. FCC compliance: Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Page 5
battery information. The battery is marked with this symbol, which may include lettering to indicate cadmium (Cd), lead (Pb), or mercury (Hg). For proper recycling, return the battery to your supplier or to a designated collection point. For more information see: www.recyclethis.info Industry Canada ICES-003 Compliance This device meets the CAN ICES-3 (B)/NMB-3(B) standards requirements.
Symbol Conventions The symbols that may be found in this document are defined as follows. Symbol Description Indicates a hazardous situation which, if not avoided, Danger will or could result in death or serious injury. Indicates a potentially hazardous situation which, if not avoided, could result in equipment damage, data Caution loss, performance degradation, or unexpected...
Safety Instruction Laws and Regulations Use of the product must be in strict compliance with the local laws and regulations. Please shut down the device in prohibited area. Power Supply • Use of the product must be in strict compliance with the local electrical safety regulations.
Page 8
• DO NOT expose the device to extremely hot, cold, or humidity environments. For temperature and humidity requirements, see device specification. • The device can only be safely used in the region below 2000 meters above the sea level. Maintenance •...
Page 9
• The battery must be charged and discharged every three months if it is not used, and recharged to 60% to 70% power percentage to store. • The scrapped battery should be discarded in compliance with the local laws and regulations. If there are no corresponding laws or regulations, throw it in a hazardous trash can.
1 Product Introduction 1.1 Introduction Body camera (hereinafter referred to as device) highly integrates with record, taping, capture, positioning, etc. It is embedded with positioning module with high sensitivity to locate the occurring position of events accurately. It can record the process and condition of events completely via record, taping, and capture.
Page 11
Figure 1-1 Appearance Table 1-2 Appearance Description Name Description Lens For recording and capture. •If you set IR as ON, the IR lights will be enabled during recording. •If you set IR as AUTO, the IR IR lights lights will be enabled automatically during recording or remote live view when the illumination is insufficient.
Page 12
Name Description For voice collection. After the device starts up, hold the recording button to enable Laser laser light which can point to light the center of the image. Then hold it again to disable laser light. Mini USB interface Open the plug to connect to and 3G/ data cable or insert 3G/4G SIM...
Name Description In menu, configuration, and input mode, tap it to enter the sub-menu, and confirm the selection or entered content. After the device starts up, hold Alarm it to send the alarm signal to the connected platform manually. After the device starts up, hold it to set the device as a MIC or loudspeaker to start two-way audio.
Page 14
Steps 1. Parallel the sheet metal buckle of the shoulder clip with the shoulder clip slot on the front panel of the device, and insert the shoulder clip into the slot as the direction shown below. Figure 2-1 Install Shoulder Clip 2.
Figure 2-3 Install 3G/4G SIM Card 3. Close the card slot plug. 2.3 Charge When the device is in low battery, charge it in time. Steps 1. Open the mini USB interface plug on the side of the device. 2. Connect one end of the USB data cable to the device, and the other end to the charger to charge the device.
Page 16
3.2 Storage The recorded video, taped audio, and captured picture will be stored in the device. 3.2.1 Record You can record video via the device. Steps 1. Press (recording button) to start record. • Press the recording button in the sleeping mode. The screen will not be woken up if the voice prompt is enabled, or the LED indicators are enabled, or voice prompt and LED indicators are enabled at the same time.
Page 17
2. Optional: Select Playback on the main menu to view the captured pictures. 3.3 Playback You can play back video, audio, and picture via the device. Steps 1. Select Playback. 2. Select Video, Audio, or Picture. 3. Select the file to play or view from the file list. 4 FAQ 4.1 Why does the device fail to start up? Possible Reason...
Page 18
Possible Reason 3G/4G SIM card is fees owed. Solution Renew the card. Possible Reason The device is abnormal. Solution Reboot the device. 4.4 Why cannot the device be logged in to via Body Camera Assistant? Possible Reason The password is incorrect. Solution Reset your password.
Need help?
Do you have a question about the DS-MCW407 Series and is the answer not in the manual?
Questions and answers