Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for HIKVISION AE-VC255T
Summary of Contents for HIKVISION AE-VC255T
- Page 1 Vehicle-Mounted Camera User Manual UD31140B...
- Page 2 Hikvision marks are the property of Hikvision and are registered trademarks or the subject of applications for the same by Hikvision and/or its affiliates. Other trademarks mentioned in this manual are the properties of their respective owners. No right of license is given to use such trademarks without express permission.
- Page 3 Regulatory Information FCC Information FCC compliance: This equipment has been tested and found to comply with the limits for a digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
-
Page 4: Safety Instruction
Safety Instruction These instructions are intended to ensure that user can use the product correctly to avoid danger or property loss. The precaution measure is divided into “Warnings” and “Cautions” Warnings: Serious injury or death may occur if any of the warnings are neglected. -
Page 5: Symbol Conventions
(which is not a malfunction), and affect the endurance of sensor at the same time. The sensor may be burned out by a laser beam, so when any laser equipment is in using, make sure that the surface of sensor will not be exposed to the laser beam. -
Page 6: Product Features
1 Introduction 1.1 Product Features This series of camera adopts new generation sensor with high sensitivity and advanced circuit design technology. It features high resolution, low image distortion and low noise, etc., which makes it suitable for monitoring system and image processing system. The main features are as follows: 2 MP progressive scan CMOS ... -
Page 7: Installation
1.4 Aviation Plug Cable The power supply for the camera is DC 9 V to 16 V wide voltage range mobile DC. Make sure that your cable matches with the plug. A Sequence B Sequence BM Sequence 2 Installation Before you start: Please make sure that the device in the package is in ... - Page 8 Steps: 1. Clean the mounting surface with a mixture of isopropyl and water. Clean the Surface 2. Tear off the release paper on the camera body. Stick the camera to the installation surface with the "UP" sign on top. Press it for 15-20 s. Tear Off the Release Paper Keep the camera staying there for over 12 h to avoid the disintegration of the glue.
- Page 9 4. Adjust the angle of the camera by adjusting the adjustment structure with a screw, then tighten the fixing screw and recover the cover of the camera Adjust the Angle...
Need help?
Do you have a question about the AE-VC255T and is the answer not in the manual?
Questions and answers