Viewing System Information; Test Of The Actuators On The System - Bosch FB 100 Installation And Operating Instructions Manual

US/CA
8.7

Viewing system information

Installer settings: System info
Menu structure page 34.
Shows a variety of system information:
Boiler part number (fixed setting from boiler)
•
Boiler date of manufacture (fixed setting
•
from boiler)
Controller part number and model (fixed
•
factory setting)
Controller date of manufacture (fixed factory
•
setting)
Controller software version (fixed factory
•
setting)
Menu settings INSTALLER SETTINGS (for installers only) | 41
8.8
INSTALLER SETTINGS: Output test
For menu structure and adjustment range
page 34.
The Output test menu gives you the opportunity
to activate individual actuators (pumps, mixing
valves) individually to check their function.
Stop all output tests: Use this parameter to
•
reset the activation of all actuators to Auto.
Heating circuit pump:
•
– Auto: Control of the pump according to the
– Manual ON: Pump always on
– Manual OFF: Pump off
Heating circuit mixer:
•
– Auto: Control of the mixing valve according
– Manual 100 % open: Mixing valve in open
– Manual 50 % open: Mixing valve in middle
– Manual 0 % open: Mixing valve in closed
Test of the actuators on the
system
As long as one or several actuators
are activated manually, a
corresponding message will be
shown on the display.
set program
to the set program
position
position
position
6 720 643 259 (2010/05)