Table of Contents
Advertisement
16 | Operation
5
Operation
The FB 100 offers the option of
setting the desired room
temperature for the operating mode
concerned. This temperature entry
is not the actual room temperature.
This is an orientation value that
influences the required supply
temperature for the heating zone.
The information in the default display (
on page 2) and the operation always apply only
for one heating zone.
5.1
Changing the room temperature
and operating mode
5.1.1 Changing the specified room
temperature for a limited period
To change the desired room temperature
permanently,
section 6.3.2 on page 28.
B Set the desired room temperature using the
dial
.
– If the mode selector is set to
The new temperature applies until the next
switch point. After that, the temperature
specified for the switch point applies.
– If the operating mode selector is set to
/
/
: The new temperature applies
until the mode selector position is
changed. After that, the temperature
specified for the selected operating mode
applies.
6 720 643 259 (2010/05)
5.1.2 Changing the operating mode (time-
limited)
To change the operating mode permanently,
section 5.1.4 on page 17.
Fig. 1
This function is only available when
switched on.
Press and release
B
next switch point and the associated
operating mode Comfort
Frost
current time.
The display shows the changed settings.
Press and hold
B
the dial
At maximum, the switch point can be changed
between the current time and the switch point
after the next one.
On exceeding of the next switch point of the
heating program, the function is reset and
:
automatic operation is active again.
Premature termination of the function:
Press
B
The function can be used in
situations such as going to bed
earlier, being away from home
longer or coming back earlier.
to bring forwards the
for the selected heating circuit to the
and simultaneously turn
to change the next switch point.
again briefly.
US/CA
mode is
/ Economy
/
Advertisement
Table of Contents
Troubleshooting
