Operation - Bosch BRC3600 Owner's Manual

Requirements
The eBike can then only be switched on when the fol-
lowing requirements are met:
– A sufficiently charged eBike battery is inserted (see
operating instructions for the eBike battery of the
system generation the smart system).
– The speed sensor is connected properly (see oper-
ating instructions for the drive unit of the system
generation the smart system).
Before setting off, make sure that you can easily
reach the buttons on the operating unit. It is recom-
mended to align the plus/minus buttons level so that
it is almost perpendicular to the ground.
Control unit power supply
If a sufficiently charged eBike battery is inserted into
the eBike and the eBike is switched on, the internal
battery of the operating unit is powered and charged.
If the state of charge of the internal battery of the op-
erating unit is very low, you can charge it via the diag-
nostics connection (10) with a USB Type-C® cable us-
ing a power bank or another suitable power source
(charging voltage 5 V; charging current
max. 600 mA).
Always close the flap of the diagnostics connec-
tion (10) so that no dust or moisture can enter.
Switching the eBike on/off
To switch on the eBike, briefly press the on/off but-
ton (2). After the start animation, the state of charge
of the eBike battery is displayed in color with the bat-
tery charge indicator (3) and the set assistance level
with the indicator (5). The eBike is ready to ride.
The display brightness is controlled by the ambient
light sensor (1). Therefore, do not cover the ambient
light sensor (1).
The drive is activated as soon as you start pedaling
(except at assistance level OFF). The drive output de-
pends on the settings of the assistance level.
As soon as you stop pedaling when in normal opera-
tion, or as soon as you have reached a speed of
Bosch eBike Systems

Operation

20/28 mph, the drive switches off the assistance.
The drive is automatically re-activated as soon you
start pedaling again and the speed is below
20/28 mph.
To switch off the eBike, press the on/off button (2)
briefly (< 3 s). The battery charge indicator of the
eBike battery (3) and the assistance level LED (5) go
out.
If no power is requested from the drive for approx.
10 minutes (e.g. due to the eBike being stationary)
and no button is pressed, the eBike switches off auto-
matically.
Quick menu
Selected settings are displayed on the quick menu.
These settings can also be changed while riding.
The quick menu can be accessed with a long press
(> 1 s) of the select button .
It cannot be accessed from the status page.
The following settings can be changed via the quick
menu:
– <Reset trip>
All data on the distance traveled so far is set to zero.
– <eShift> (optional)
The settings are dependent on the respective gear-
shifting.
Note: Depending on the configuration of your eBike,
additional functions may be available.
Battery charge indicator of the eBike
battery
In the battery charge indicator of the eBike bat-
tery (3), each ice-blue bar represents 20 % capacity
and each white bar represents 10 % capacity. The
topmost bar shows the maximum capacity.
Example: Four ice-blue bars and one white bar are
displayed. The state of charge is between 81 % and
90 %.
If capacity is low, both of the lower displays change
color:
English – 9
0 275 U07 3RL | (08.03.2023)