Setting Beeper Volume; Choosing The Handset Volume (For Volume Amplify) - Brother FAX-775 Owner's Manual

Setting Beeper Volume

You can set the beeper to LOW,
the beeper is set to
or make an error, and at the end of fax sending or receiving.
1
Press Menu/Set, 1, 3.
2
or
Press to select your setting, and then press Menu/Set.
3
Press Stop/Exit.

Choosing the Handset Volume (For Volume Amplify)

Before you begin to use the machine, you must decide if you need to set the handset
volume to AMPLIFY:ON
volume level complies with FCC standards.
VOLUME AMPLIFY: OFF
This default setting is appropriate if none of the users are hearing-impaired. During a
conversation, users can press Volume
to LOW or HIGH. When the handset is replaced, the handset volume will remain
until you change it again.
VOLUME AMPLIFY: ON–TEMPORARY
This setting is appropriate if some of the users are hearing-impaired. During a
conversation, users can press Volume
to LOW, HIGH
returns to the default setting of LOW.
VOLUME AMPLIFY:ON–PERMANENT
Choose VOL AMPLIFY:ON–PERMANENT
impaired. During a conversation, users can press Volume
adjust the volume to LOW,
handset volume returns to the default setting of AMPLIFY.
When you press Volume
the setting you are choosing. Each key press changes the volume to the next setting.
WARNING
It is important that you do not choose PERMANENT unless all users are
hearing-impaired. Otherwise, the default setting of AMPLIFY may damage the
hearing of some users.
HIGH
LOW or HIGH, the fax machine beeps every time you press a key
for a user who is hearing-impaired. The AMPLIFY
or AMPLIFY. When the handset is replaced, the handset volume
HIGH or AMPLIFY. When the handset is replaced, the
or
on the control panel to adjust the volume, the LCD shows
or OFF. The default setting is LOW. When
or
on the control panel to adjust the volume
or
on the control panel to adjust the volume
if all of the users are hearing-
or
I N I T I A L S E T U P
on the control panel to
4 - 4