Setting Beeper Volume; Setting The Speaker Volume; Setting The Ring Volume; Memory Storage - Brother FAX-202 Owner's Manual

Setting Beeper Volume

You can set the beeper to LOW, HIGH or OFF. The default setting is LOW. When
the beeper is set to LOW or HIGH, the fax machine beeps every time you press a key
or make an error, and at the end of fax sending or receiving.
1
Press Function/Set, 1, 3.
2
Press or
3
Press Stop to exit.

Setting the Speaker Volume

You can adjust the speaker volume when your fax machine is on hook (after you
pressed Hook or Speaker Phone), by selecting a speaker volume level.
Press or
choosing. Each key press changes the volume to the next setting. The new setting will
remain until you change it again.
If you have FAX-333MC, you can adjust the speaker volume while you are listening
to your OGM (Outgoing Message) and ICMs (incoming messages).
If you turn Incoming Recording Monitor to OFF (Function/Set, 8, 5) on the
FAX-333MC, the Speaker for screening calls will be disabled and you won't hear
callers leaving messages. The volume for other operations can still be controlled
using and

Setting the Ring Volume

You can adjust the ring volume when your fax machine is idle. You can select a ring
volume level or press until the ring is off.
Press or
rings so you can hear the current setting and the display shows the setting you are
choosing. Each key press changes the volume to the next setting. The new setting will
remain until you change it again.

Memory Storage

In the event of a power failure, all settings in the INITIAL SETUP, SETUP
RECEIVE, SET AUTO DIAL, REMOTE FAX OPT and SETUP MSG CTR plus the
COVERPG SETUP and COVERPAGE MSG (from SETUP SEND) functions are
stored permanently. You may have to reset the date and time.
4 - 4
I N I T I A L S E T U P
to select your setting and press Function/Set.
to adjust the volume level. The display shows the setting you are
.
to adjust the volume level. With each key press, the fax machine