Parameters; Dis-/Enable; Ip Configuration / Stationid; Ip Configuration / Stationid\ Ip Configuration Mode - LinMot CC-Link IE Field Basic C1250-CC Series Manual

Csp+
Table of Contents

Advertisement

3.1 PARAMETERS

Basic), which can be configured with the distributed LinMot-Talk software.
With these parameters, the CC-Link IE Field Basic behaviour can be configured.
The LinMot-Talk software can be downloaded from http://www.linmot.com.

3.1.1 Dis-/Enable

With the Dis-/Enable parameter the LinMot device can be run without the CC-Link IE Field Basic Interface
going online. So in a first step the system can be configured and run without any bus connection.
CC-Link IE Field Basic\ Dis-/Enable
Disable
Device runs without CC-Link IE Field Basic.
Enable
Device runs with CC-Link IE Field Basic.
Important: If the CC-Link IE Field Basic Interface is disabled, the integrated CC-Link IE Field Basic
switch is not powered! No messages will be sent to other devices connected to the network via the
LinMot device.

3.1.2 IP Configuration / StationID

In this section the IP-Address / StationID can be configured.
CC-Link IE Field Basic\ IP Configuration / StationID
IP Configuration Mode
IP address / StationID 1st Byte
IP address / StationID 2nd Byte
IP address / StationID 3rd Byte
IP address / StationID 4th Byte
Netmask 1st Byte
Netmask 2nd Byte
Netmask 3rd Byte
Netmask 4th Byte
Default Gateway IP 1st Byte
Default Gateway IP 2nd Byte
Default Gateway IP 3rd Byte
Default Gateway IP 4th Byte

3.1.3 IP Configuration / StationID\ IP Configuration Mode

In this section the method how to obtain the IP-Address / StationID is configured.
Page 6 of 12
Selects how the IP-Address /
StationID is obtained.
1st byte of device IP address.
2nd byte of device IP address.
3rd byte of device IP address.
4th byte of device IP address.
1st byte of device Netmask.
2nd byte of device Netmask.
3rd byte of device Netmask.
4th byte of device Netmask.
1st byte of the default gateway IP
address.
2nd byte of the default gateway IP
address.
3rd byte of the default gateway IP
address.
4th byte of the default gateway IP
address.
Default value
Use configured IP with Hex
Switches S1 and S2 as lowest
byte
192
168
3
1
255
255
255
0
0
0
0
0
NTI AG / LinMot

Advertisement

Table of Contents
loading

Table of Contents