Intel ISP1100 Installation Manual page 6

Internet server, rail option kit

Hide thumbs Also See for ISP1100:

Attach the Brackets to the Rail Assemblies

The brackets attach to the rack sections of the rail assemblies and then to the rack.

Each rail assembly needs a front and a rear bracket.

Attaching the Front Bracket

Slide the rack section so the screw holes show through the rectangular opening

(A) in the slider section (B).

Place the front bracket (C) against the rack section as shown.

Line up the slot in the bracket with the holes in the rack section.

Fasten the front bracket to rack section with two 8/32 x 0.38" flathead counter-

sunk phillips screws (D). Each screw takes a regular washer, a lock washer and a

nut (E). Put the washers and nut on in the order shown.

Attaching the Rear Bracket

There are two steps to attaching the rear bracket:

Determine where to attach the bracket.

The bracket attaches to the back end of the rack section. However, the exact

placement depends on the depth of your rack. Because the rack section is a fixed

length, you use the bracket placement to set the rail assembly length so the rail

assembly fits your rack.

Intel ISP1100 Internet Server Rail Kit

OM09761