Table of Content 1. Introduction ......................... 2 2. Appearance ......................... 2 3. Main Feature ....................... 3 4. Set Up Instruction ....................... 4 5. Data Report ......................... 5 6. Information about Battery Passivation ............... 6 7. Important Maintenance Instruction ................7...
R718PA9 is a ClassA device based on the LoRaWAN open protocol of Netvox and is compatible with LoRaWAN protocol. R718PA9 can be connected with an ORP sensor (RS485), and report the ORP value of the solution collected by the device to the corresponding gateway. The device is compatible with LoRaWAN protocol.
⚫ Applicable to the third-party platforms: Actility/ ThingPark/ TTN/ MyDevices/ Cayenn Note: Battery life is determined by the sensor reporting frequency and other variables, please refer to http://www.netvox.com.tw/electric/electric_calc.html On this website, users can find battery lifetime for varied models at different configurations.
4. Set Up Instruction On/Off Power On DC12V adapter Press and hold the function key for 3 seconds till the green Turn On indicator flashes once. Press and hold the function key for 5 seconds, and the green Turn Off (Restore to factory setting) indicator flashes 20 times.
0. Note: 1.Report interval is based on the factory default. 2.R718PA9 reports the ORP value. The device reported data parsing please refer to Netvox LoraWAN Application Command document and Netvox Lora Command Resolver http://www.netvox.com.cn:8888/page/index Report Con figuration Device Description...
6. Information about Battery Passivation Many of Netvox devices are powered by 3.6V ER14505 Li-SOCl2 (lithium-thionyl chloride) batteries that offer many advantages including low self-discharge rate and high energy density. However, primary lithium batteries like Li-SOCl2 batteries will form a passivation layer as a reaction between the lithium anode and thionyl chloride if they are in storage for a long time or if the storage temperature is too high.
Note: Please do not disassemble the device unless it is required to replace the batteries. Do not touch the waterproof gasket, LED indicator light, function keys when replacing the batteries. Please use suitable screwdriver to tighten the screws (if using an electric screwdriver, it is recommended to set the torque as 4kgf) to ensure the device is impermeable.