AZEK Timbertech Impression Rail Express Installation Manual page 2

Important Information
• Please read all instructions completely before starting any part of the installation. Always make sure to visit www.TimberTech.com.au to
ensure you are viewing the most current installation instructions, care and cleaning, technical information and more.
• Impression Rail Express should be installed using the same good building principles used to install wood, composite, or metal balustrade
and in accordance with the local building codes and the installation guidelines included below.
• The AZEK Co. LLC accepts no liability or responsibility for the improper installation of this product.
• Impression Rail Express may not be suitable for every application and it is the sole responsibility of the installer to be sure that Impression
Rail is fit for the intended use. Since all installations are unique, it is also the installer's responsibility to determine specific requirements in
regards to each balustrade application.
• The AZEK Co. LLC recommends that all applications be reviewed by a licensed architect, engineer or local building official before
installation. If you have any questions or need further assistance, please call TimberTech Customer Service at 1-800-726-300, or visit our
website at www.TimberTech.com.au.
• Impression Rail Express is tested as a whole system and should be used that way. It is not intended to be used in conjunction with other
balustrade systems or fasteners.
• The following Installation Guidelines are applicable for installation of Impression Rail Express only.
• IMPORTANT: Make sure the DRIVE TOOL/DRILL is configured or set to use the SCREW setting when driving and/or tightening all
FASTENERS.
• SAFETY: Always wear goggles when handling, cutting, drilling and fastening materials.
• Failure to install this product in accordance with applicable building codes and Impression Rail Express's written Balustrade Install Guide
may lead to personal injury, affect balustrade system performance and void the product warranty.
• The buildup or generation of static electricity is a naturally occurring phenomenon in many plastic based products such as carpeting,
upholstery, and clothing, and can occur on alternative decking under certain environmental conditions. This static electricity can discharge
once contact is made with hardware, balustrade, or other conductors of electricity.
Installing Impression Rail
Aluminium Balustrade System
NOTE: IF INSTALLING POST LIGHTING,
WIRING MUST BE INSTALLED PRIOR TO
SECURING POSTS TO DECK/STAIR SURFACE
AND INSTALLING HAND RAIL SNAPS.
It is the responsibility of the installer to
meet all local code requirements and obtain
all required building permits. The installer
should determine and implement appropriate
installation techniques for each installation
situation. AZEK Co. LLC or its reseller shall
not be held responsible for improper or
unsafe installations.
Page 2
Express
™