Brother DCP-7020 User Manual page 42

Chapter 6
ERROR MESSAGES
ERROR MESSAGE CAUSE
The inside of the machine is too hot.
Machine too Hot
The toner cartridge is not installed
No cartridge
properly.
The DCP is out of paper or paper is not
No Paper Fed
properly loaded in the paper tray.
The DCP's memory is full.
Out of Memory
Paper jam Inside The paper is jammed inside the DCP.
The paper is jammed in the back of the
Paper Jam Rear
DCP.
The paper is jammed in the paper tray
Paper Jam Tray
of the DCP.
The scanner needs to be reset.
Scanner Locked
The toner cartridge and drum unit
Toner Life End
assembly are not installed.
—OR—
Toner is used up and printing is not
possible.
The toner cartridge is near the end of its
Toner Low
life and the toner will soon run out.
The DCP has a mechanical problem.
Unable to Init.
(Initialize)
Unable to Print
Unable to Scan
6 - 2
ACTION
Make sure you can hear the fan in the DCP spinning
and the exhaust outlet isn't blocked by something.
If the fan is spinning, remove some obstacles that
surround the exhaust outlet, and then leave the DCP
for several minutes.
If the fan is not spinning, turn off the DCP and then turn
it on again.
Reinstall the toner cartridge.
Refill the paper in the paper tray.
—OR—
Remove the paper and load it again.
(Copy operation in process)
Press Stop/Exit and wait until the other operations in
process finish and then try again.
(Printing operation in process)
Reduce print resolution. (See Advanced tab in the
Software User's Guide on the CD-ROM.)
(See Paper jams on page 6-4.)
(See Paper jams on page 6-4.)
(See Paper jams on page 6-4.)
Turn off the DCP and then turn it on again.
Re-install the toner cartridge and drum unit assembly.
—OR—
Replace the toner cartridge with a new one. (See
Replacing the toner cartridge (TN-350) on page 6-19.)
Order a new toner cartridge now.
Turn off the DCP's power switch, and then on again, If
the error message continues, leave the DCP for
several minutes and try it again.