Trouble-Shooting; Decommissioning; Dismantling And Disposal - Conti LT 5 Instruction Manual

TROUBLE-SHOOTING

The following table indicates:
 The description of the problem or the most likely symptoms of malfunctioning.
 The cause/s of potential damage.
 Remedies.
PROBLEM
Power supply plug disconnected
The machine
Mains switch turned off
doesn't start
Bowl peg sensor missing
See previous causes
Pressing the start
Protection opened
key, the
Emergency button pressed
accessory does
not rotate
Bowl not positioned on the support
Bowl not in working position (high)
The accessory
The phases of the machine do not
rotates counter-
correspond with the power supply line
clockwise
Loss of RPM on
Drive belts loosened or worn
the accessory
Irregular rotation Drive belt loosened or worn
of the accessory
Eccentric pinion damaged

DECOMMISSIONING

 Stop the work cycle of the machine.
 Interrupt the electrical power supply using the mains switch n.1 to position 0.
 Remove the power supply plug.
 Move the machine to a storage facility.
 Cover the machine with a nylon sheet.
 Apply a sign with the words "OUT OF SERVICE".

DISMANTLING AND DISPOSAL

No element of the machine must be disposed of in the environment.
Every part, component, or group of components must be separated according to the type of material.
The laws in force at the time of disposal must be observed.
The symbol on the device, as illustrated here, indicates that it must not be disposed of as urban
waste, but must be transported separately to a WEEE collection centre specifically organised for the
adequate treatment of electrical and/or electronic apparatus. See Directive 2002/96/EC of the
European Parliament and Council dated 27 January 2003 on wastes from electrical and electronic
equipment.
Incorrect disposal or inappropriate use of the equipment or parts of it may cause potentially
negative and harmful effects on the environment and human health.
ENGLISH
CAUSE
22
REMEDY
Connect the plug
Turn on the main switch
Replace with a new one
Connect the plug or turn on the mains
switch
Close the accident-prevention device
Reset the emergency button
Position the bowl on the support
Bring the bowl into working position
Ask a professional electrician to switch the
phases on the plug
Tighten the belts or replace them
Tighten or replace the belt
Replace the pinion