Transport, Handling And Storage - Electrolux E9BSGLIUFE Spare Parts Diagram

1.10 PERSONAL PROTECTION EQUIPMENT
Given below is a summary table of the Personal Protection
Equipment (PPE) to be used during the various stages of the
machine's service life.
Protective
garments
Stage
Transport
Handling
Unpacking
Assembly
Normal use
Adjustments
Routine
cleaning
Extraordinary
cleaning
Maintenence
Dismantling
Scrapping
Key:
During Normal use , gloves protect hands from contact with
hot food or hot parts of the appliance.
1.11 KEEPING THE MANUAL
The manual must be carefully kept for the entire life of the
machine, until scrapping.
The manual must stay with the machine in case of transfer,
sale, hire, granting of use or leasing.
1.12 RECIPIENTS OF THE MANUAL
This manual is intended for:
• the carrier and handling personnel;
• installation and commissioning personnel;
• the employer of machine users and the workplace manager;
• operators for normal machine use;
• specialised technicians - After-Sales Service.

2. TRANSPORT, HANDLING AND STORAGE

2.1 INTRODUCTION
Transport (i.e. transfer of the machine from one place to
another) and handling (i.e. transfer inside workplaces) must
occur with the use of special and adequate means.
ATTENTION!
Given their size, the machines can be stacked
on top of each other during transport, handling
and storage by complying with that specified on
the slip placed on the packing;
Safety Safety
Gloves Glasses
footwear
helmets
PPE REQUIRED
PPE AVAILABLE OR TO BE USED IF NECESSARY
PPE NOT REQUIRED
The machine must only be transported, handled and stored
by qualified personnel, who must:
- have specific technical training and experience in the use
of lifting systems;
- have knowledge of the safety regulations and applicable
laws in the relevant sector;
- have knowledge of the general safety rules;
- ensure the use of personal protection equipment suitable
for the type of operation carried out;
- be able to recognise and avoid any possible hazard.
2.2 TRANSPORT: INSTRUCTIONS FOR THE CARRIER
ATTENTION!
Do not stand under suspended loads during
loading/unloading operations. Unauthorised
personnel must not enter the work area.
ATTENTION!
The machine's weight alone is not sufficient to
keep it steady. The transported load can shift:
- when braking;
- when accelerating;
- in corners;
- on rough roads.
2 . 3 HANDLING
Arrange a suitable area with flat floor for machine unloading
and storage operations.
2.4 PROCEDURES FOR HANDLING OPERATIONS
For correct and safe lifting operations:
• use the type of equipment most suitable for characteristics
and capacity (e.g. electric pallet truck or lift truck);
• cover sharp edges;
Before lifting:
• send all operators to a safe position and prevent persons
from entering the handling area;
• make sure the load is stable;
• make sure no material can fall during lifting. Manoeuvre
vertically in order to avoid impacts;
• handle the machine, keeping it at minimum height from
the ground.
ATTENTION!
For machine lifting, do not use movable or weak
parts such as: casings, electrical raceways,
pneumatic parts, etc.
27