Reset; How To Reset; Packing And Shipping The Machine - Brother DCP 8085DN User Manual

Reset

The following reset functions are available:
1 Network
You can reset the print server back to its
default factory settings such as the
password and IP address infromation.
2 All Settings
You can reset all the machine settings
back to the settings that were set at the
factory.
Brother strongly recommends you
perform this operation when you dispose
of the machine.
Note
Unplug the interface cable before you
choose Network or All Settings.

How to Reset

a
Press Menu, 1, 8.
b
Press a or b to choose the reset you
want.
Press OK.
c
Press a or b to choose 1.Reset or
2.Exit.
Press OK.
d
If you choose 1.Reset in step c, you
will be asked to reboot the machine.
Press a or b to choose 1.Yes or 2.No
Press OK.
If choose 1.Yes, the machine will begin
the Reset.
Note
You can also reset the Nerwork settings
by pressng Menu, 5, 0.
102
Packing and shipping
C
the machine
CAUTION
Make sure that the machine has fully
cooled down by leaving it disconnected
from the power for at least 30 minutes
before packing.
When you transport the machine, use the
packing materials that came with your
machine. If you do not pack the machine
correctly, you could void your warranty.
a
Turn off the machine.
b
Unplug all the cables and AC power
cord from the machine.
c
Push the Scanner Lock Lever down to
C
lock the scanner. This lever is located on
the left of the scanner glass.
IMPORTANT
Damage caused to your machine by
failure to lock the scanner before packing
and shipping may void your warranty.
d
Press the front cover release button and
open the front cover.
e
Take out the drum unit and toner
cartridge assembly. Leave the toner
cartridge installed in the drum unit.
C