Table of Contents
Advertisement
Power Up the System
1 Ensure that both Emergency Stop buttons (at the front and rear of the system)
2 Switch ON the Power On/Off switch at the rear of the system.
3 Switch ON the air pressure valve to start the air supply to the system.
4 Press the Reset button on the control panel.
5 Check that the controller and monitor are on.
i7090 System Installation
are released.
Adjust the air regulator knob until the pressure gauge on the control panel
shows a reading that is between 4 and 6 bar (0.4 to 0.6 MPa).
Air regulator knob
Air pressure valve
Power Up the System
13
Advertisement
Table of Contents
