Connection To The Factory Monitor - r.LiNK RL2-NBT Manual

Connect white female 6pin Molex connector of the 6pin to 8pin cable to the male
6pin Molex connector of the video-interface.
Connect black female 8pin Micro-Fit connector of the 6pin to 8pin cable to male 8pin
Micro-Fit connector of the CAN-box.
Note: Check LEDs on video-interface after reconnecting the battery, one must be on.
Connect red-green drilled cable of 6pin of 8pin cable to the male 4pin connector of
the video-interface.
Note: The CAN-box is not compatible with all vehicles. If the CAN-box does not deliver ACC
to pin2 of the video-interface or blocks the vehicle CAN, it is possible to install without CAN-
box. In this case see also note in chapter after-market rear-view camera if one is supposed to
be connected.
2.4. Connections to the factory monitor
Remove factory monitor.
Remove female 4 + 2pin HSD LVDS connector from the rear of the factory monitor
and connect it to the male 4 + 2pin HSD LVDS connector of the video-interface.
Connect female 4pin connector of the 4 + 2pin HSD LVDS cable to the male 4pin HSD
LVDS connector of the factory monitor.
Connect female 2pin connector of the 4pin cable to the male 8pin MB connector
of the factory monitor.
Note: If the HSD2 image cable of the vehicle harness is too short for the installation, an HSD2
extension can be ordered separately with item number CAB-HSD2-MF100B.
Version 26.04.2021 HW CAM(V31)/(V71) RL2-NBT