Vinten Vision 5LF Maintenance Manual page 22

Contents
Brake knob adjustment
8 The pan and tilt brakes are set during manufacture so that, when the brakes are fully applied, the knob
is vertical. As the brakes bed in during use it may be necessary to reset the knobs to this position.
9 The procedure for resetting the pan and tilt brake knobs is as follows
9.1 Prise out the centre of the appropriate brake knob (5).
9.2 Turn the knob
9.3 Remove the screw
9.4 Refit the knob on the shaft in the vertical position.
9.5 Turn the knob fully counter-clockwise and ensure the brake is released.
9.6 Turn the knob clockwise and ensure that the brake is fully applied when the knob is vertical.
Adjust the position of the knob if necessary.
9.7 Secure the knob with the screw
Fig 4.2 Brake knob adjustment
(2) clockwise to fully apply the brake.
(3) and washer (4)
(3) and washer (4). Refit the knob centre (4), using Silcoset 153.
and pull the knob (2) off the shaft (1).
First Previous Next
Page Page Page
(Fig 4.2):
Previous
View
(1)
(2)
(3)
(4)
(5)
22