Advertisement
2.
power (S). While the scooter power is on, press the power button (S) once, the headlight
and rear light should be turned on. Press (S) one more time, the headlight & rear light will
be turned off.
Accelerator The right thumb control is the accelerator (S2). The further you press the
3.
accelerator down, the more energy you will release to the motor. NOTE:
motor
speeds. Operate your SNAPnGO at a reasonable speed for both your personal safety and
others.
4.
to F position, it means forward. When switch to R position, it means reverse. The reverse
mode has a top speed of 2-3m
If the scooter is on reverse mode, scooter will move backward when throttle (S2) is
pressed.
5.
The left brake handle is the mechanical brake (H). The scooter is on electronic
braking when power is on and the right accelerator is not pressed. The mechanical brake
in the left rear wheel provides added safety for emergency purpose. When actuated, it will
cut power supply to the motor.
. The parking brake tab (H1) could be actuated by pressing towards the brake
lever when the brake lever (H) is squeezed. Squeeze brake lever (H) one more time to
release the parking brake (H1). See details in the Parking Brake section.
6.
scooter. The speed for setting 1 is 3-4 kmh or 2 mph, 2 is 7-8 kmh and 3 is 10-12 kmh. We
recommend speed 1 as your default setting. Speed setting 3 has the most torque and
speed. Operate your SNAPnGO at a reasonable speed for both your personal safety and
others. Always slow down before turning.
When power is on, you can press the horn (G) to give alerts.
7.
06/15/21
To turn the headlight/tail on or off, you must first turn on the scooter
.
The reverse control (T1) is located on the left side. When switch forward
Toggle the speed setting to control the maximum speed of the
b
20
Advertisement
