Connecting Your Terminal Base To Power; Turning The Terminal On; Configuring Your Terminal; Charging Your Terminal - Westpac EFTPOS CONNECT Quick Reference Manual

Connecting your terminal base to power.

You can connect your terminal base to power as shown below.
Option 1

Turning the terminal on.

Hold the 'ENTER' key down for about 2 seconds until the terminal displays the start-up screen.
Alternatively, place the terminal onto the base.

Configuring your terminal.

Once your EFTPOS Connect terminal is connected, the Linkly Client software needs to be
installed and set-up.
If you need assistance with the installation you can contact Linkly Support:
(02) 9998 9800
or your POS Vendor.

Charging your terminal.

Make sure your terminal base is connected to a power source and place your terminal on the
base to charge. The charging symbol
terminal will automatically turn on.
6
Option 2
•
Connect
Please note this option is applicable for
Serial/RS232 connectivity. A separate power cable
is provided with the terminal.
will appear on screen once charging begins and your
Connect
Serial/
RS232