Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Magnum METRO
Summary of Contents for Magnum METRO
- Page 1 MAGNUM METRO / METRO + USER GUIDE Please read before use! www.magnumbikes.com...
- Page 2 All texts, illustrations and instructions in this manual are based on information at the time of printing. The information contained in this manual is valid at the time of issue. Reproduction, duplication or translation of this user manual is prohibited without explicit permission from Magnum Bikes. All rights under the copyright law remain expressly reserved.
-
Page 3: Table Of Contents
Table of Contents Service Function and operation of handlebar components Mounting instructions for handlebars Pedal installation Seating position Adjusting the seat height Adjusting the saddle Suspension fork Safety instructions for charger Charger functions Safety precautions for battery Handling of the battery and charger Charging the battery Tire pressure Support level... -
Page 4: Function And Operation Of Handlebar Components
RIGHT SIDE VIEW 1. Display 6. Motor 2. Brakes 7. Derailleur 3. Seatpost 8. Crankset 4. Battery 9. Pedals 5. Disk brake Function and operation of handlebar components 1. Display 4. Right grip 2. Left grip 5. Right shift lever 3. -
Page 5: Mounting Instructions For Handlebars
Mounting instructions for handlebars Adjustable handlebar 1. Install the handlebars as shown and tighten the upper screw. 3. Move the handlebar up or down to the desired position. If it is too loose or too tight, please adjust the screw on the handlebars. - Page 6 2. Adjust the handlebar to the desired position and tighten the screws on the right side. 4. Close the cover plate to complete the setting.
- Page 7 Pedal mounting WARNING Do not tighten the pedals by hand, use a suitable wrench. Identify your pedal: Check the letter on the pedal: "L" or "R". The pedal marked "R" is for the right. Turn the wrench handle clockwise. The pedal marked "L" is for the left. To tighten the pedal, turn it counterclockwise.
-
Page 8: Seating Position
Seating Position To ensure comfortable, fatigue-free and safe riding, the saddle and handlebar height should be adjusted to the riders body size. The saddle height is correct when the foot is resting on the pedal at the lowest position while the leg is not fully extended. The tips of the toes should be able touch the ground. -
Page 9: Adjusting The Seat Height
Ideal SERVICE Adjust the seat height Adjusting the seat height WARNING A quick release lever that is not fully closed can open while riding allowing the saddle to move. This can lead to severe injury. The tension on the quick release lever should be strong enough to need two hands when closing. The saddle can be extended up to the “MINIMUM INSERT”... - Page 10 Important safety precautions for the charger Before using the charger, please read these safety instructions. WARNING Protect your charger from children. To prevent injury use the charger that comes with your e-bike. Other battery types can explode when charged with the incorrect charger. This can lead to personal injury and material damage. The use of accessories or batteries which are not sold or recommended by us can lead to fire, electrical shock, or injuries.
-
Page 11: Charger Functions
- Check that the outlet your charger is plugged into is functioning properly, if necessary connect other devices to it to confirm. - Check the contacts of the plug connections. - If charging is still not possible, please have the battery and charger checked by a Magnum Bikes licensed dealer. - Page 12 Important instructions for the battery Important information, which you should read before use: - The batteries of the vehicle are approximately 50% charged when new. - Before using the battery for the first time please fully charge the battery. - The battery develops its max. output after approx. five discharge / charge cycles. WARNING The battery of the bicycle is matched with the charger.
-
Page 13: Handling Of The Battery And Charger
Handling of battery and charger In order to achieve the longest possible battery life, the following notes should be observed: - The charger should not be activated when the battery temperature is below + 32 ° F or above + 140 ° F. Before charging, be sure to bring the battery to about room temperature. -
Page 14: Charging The Battery
Recharging the battery NOTE The battery (1) can be removed from the e-bike. The battery is secured with a lock (2). IMPORTANT NOTE! The new 48V battery has USB port on the right side of the battery near the top. TO CHARGE THE BATTERY Connect the plug of the charger to the power supply Connect the charger to the battery. -
Page 15: Tire Pressure
To pull out the battery, insert and turn the key. Hold the key in the unlock position (2) and then pull out battery (1). Insert the battery - To reinsert the battery push the bottom of the battery (1) into the frame as far as it will go and then insert the top end of the battery into the frame until it clicks in place. - Page 16 Riding instructions NOTE The battery must be secured and locked into the frame before riding. Before riding, be sure that the battery is correctly inserted into the frame and remove the key. If left in place the key can break in case of impact. WARNING - FALL HAZARD! WARNING - FALL HAZARD! To avoid injury be sure to follow the instructions below:...
-
Page 17: Range
The front and rear brakes operate independently of each other. When stopping or slowing down, operate both brakes at the same time. The Magnum Peak e-bike is equipped with hydraulic disc brakes, which have a very high braking power. WARNING The model with hydraulic disc brakes can achieve very rapid braking performance. - Page 18 The left brake lever (1) controls the front brake Parking the bike WARNING When unfolding the kickstand (1), always make sure that the stand is stable and firm before leaving the bike in place, so as to prevent the bike from falling over. Do not place additional weight on the bike when the kickstand is in use. NOTE Be sure that your kickstand’s adjustable leg is adjusted to the position of your preference and screw it tightly in place.
- Page 19 Section 1: ON/OFF - To power on your e-bike click the power button once. - The display will show some of your system parameters immediately when turned on. - On the bottom right you will see the systems voltage specific for your e-bike (either 36V or 48V). - In the center you will see the wheel size and on the bottom left the tire width.
- Page 20 Your e-bike parameter settings have all been factory set for your specific model and region. This includes the wheel and tire size, speed denomination (km/h or mph), power level and speed output. In order to eliminate confusion the section to change these factory settings is available only to Magnum Bikes licensed dealers and is password protected.
- Page 21 Press the SET for 5 seconds to reset TRIP 1. Section 5: 5.1) BATTERY INDICATOR 5.1.1 ) Battery level indicator The battery capacity viewing area has five segments, each representing 20% of the battery capacity. When the capacity is full, all five segments are all lit up.
-
Page 22: Riding
Be sure to use only Magnum approved replacement parts and accessories for your e-bike. Magnum Bikes will not warranty or be liable for any e-bikes that were altered, changed or otherwise tampered with or for e-bikes that have used generic replacement parts. -
Page 23: Removing The Front Wheel
● Do not ride the e-bike if any of the above is not properly secured. WARN When starting to ride your bike be sure to hold the handlebars straight. Do not start with the motor switched on until you are comfortable riding the electric bike. ●... -
Page 24: Carrying Loads
Do not cover the lights. Do not connect a trailer to the back of your e-bike without first consulting with a licensed Magnum Bikes dealer. In general, loads (shopping bags, etc.) should not be transported on the handlebars, but rather on the luggage carrier intended for this purpose. -
Page 25: Winter Operation And Corrosion Protection
Care products If necessary, the bicycle should be treated with commercially available care products that are made for bicycles. You can prevent corrosion-prone parts from becoming a precautionary measure, especially during winter, with certain care products. DANGER Do not use silicone-containing cleaning agents or varnish polishes for plastic parts. - Carefully clean the frame and aluminum parts after long rides and preserve them with a commercially available anti-corrosive agent. -
Page 26: Tire Care
Magnum Bikes will not be liable in any way for damage to the e-bike or any physical harm caused by faulty components that were attached to the e-bike by the customer after market. - Page 27 MAINTENANCE M = Maintenance by the dealer O = Test by the Owner Work to be done Before riding Monthly Yearly If necessary Check all bolts and nuts, which are important for driving safety and function, if necessary. Axle nut - steering bearing - handlebar - saddle - seatpost - brakes - pedal crank Clean chain and lubricate with chain lube.
-
Page 28: Maintenance And Care
Any work on the motor unit, the cable harness, the battery and the charger or their disassembly will void the warranty as well. Please note the following: ● All maintenance carried out during the warranty period must be done by a licensed Magnum Bikes dealer. ● Use only original spare parts. -
Page 29: Pedals
NOTE If the pedal cranks have come loose, the inner bolt has most likely been displaced. The pedal crank arms must then be re-tightened. Only dismantle the crank arm with the correct tool and be sure never to pull it out by force. When installing the crank arm all surfaces of the crank and axle must be completely free of grease. -
Page 30: Technical Specifications
The fuse for the battery is located inside the battery case. When replacing the fuse, use a 30A fuse for the discharge fuse located in the top end of the battery and 5A for the charge fuse located in the bottom part of the battery case . TECHNICAL SPECIFICATIONS Components Metro motor DAS-KIT, 48V 300W, ~40kph, rear hub motor battery pack... -
Page 31: Wear & Tear Parts List
Shimano, Acera M360, 8 speed tire Schwalbe, Big Ben, 26" * 2.25 Metro+ Components motor DAS-KIT, 48V 300W, ~40kph, rear hub motor battery pack 48V 13Ah with USB connection display DAS-KIT C7 LCD display fork RST, Neon-TNL with oil suspension and lock out... - Page 32 • Unauthorized attempts to repair the product without prior written consent by Magnum Bikes. Maintenance by a third party that is not authorized by Magnum Bikes. • Commercial use of the product. • Defects due to normal wear and tear, unless Magnum Bikes voluntarily provides goodwill service within the first year.