FUNAI B4-M500 Owner's Manual page 41

11 Press [Red] to go to the proxy port setting
screen. Enter proxy port number with
number buttons.
Network Settings (Manual)
Please input the Proxy Port.
Cancel Clear
Cancel ncel l
12 Use [K / L / s / B] to select "OK", then
press [OK].
13 Connection speed setting screen will appear.
Use [K / L] to select the desired setting,
then press [OK]. (The default setting is
"Auto".)
14 BD-Live™ setting screen will appear. Use
[K / L] to select the desired setting, then
press [OK]. (The default setting is
"Allow".)
"Allow":
Internet access is permitted for all BD-
Live™ contents.
"Limited Allow":
Internet access is permitted only for BD-
Live™ contents which have content owner
certificates. Internet access without the
certificates is prohibited.
"Prohibit":
Internet access is prohibited for all BD-
Live™ contents.
15 Connection test confirmation screen will
appear. Select "Yes" to start the connection
test and the test result will appear right after
the connection test finishes.
16 Select "End" to complete the settings.
EN
Proxy Port
xxxxx
OK
5/7
D Note for "IP Address", "Subnet
Mask", "Default Gateway", "Primary
DNS" and "Secondary DNS"
• The range of input numbers is between 0
and 255.
• If you enter a number larger than 255, the
number will automatically be 255.
• When you enter a wrong number, select
"Clear" to clear. (The number will be back
to "0".)
• If you want to enter a 1 or 2-digit number in
one cell, press [B] to move on to the next
cell.
D Note for "Proxy Address" and "Proxy
Port"
• The range of input numbers for the port
number is between 0 and 65535. (If you
enter a number larger than 65535, it will be
regarded as 65535.)
• For proxy port, certain ports might be
closed, blocked or unusable depending on
your network environment.
• Choose a connection speed in accordance
with your network environment.
• When the settings are changed, the network
connection may be disabled depending on
the device.
Network Status
You can check the current status of network
status.
1 Follow steps 1 to 2 in "Connection Test" on
page 39.
2 Use [K / L] to select "Network Status",
then press [OK].
• The current network settings will be
displayed.
3 Press [HOME] to exit.
41