Table of Contents
Advertisement
9. SETUPS
9.1
Network Connection
[HOME]
"Settings"
Set up network connection settings in order to
use BD-Live™, DLNA home media server or
network update function.
Connection Test
After you enable a network connection or
change the network settings, always perform the
connection test to check if the connection is
correctly made.
1
Use [K / L / s / B] to select "Settings" in
the home menu, then press [OK].
2
Use [K / L] to select "Network", then
press [OK].
3
Use [K / L] to select "Network
Connection", then press [OK].
4
Use [K / L] to select "Connection Test",
then press [OK].
• Connection test will start automatically and
the test result will appear right after the
connection test finishes.
"Connecting...":
Activates surround effects.
"Pass":
Deactivates surround effects.
"Failed":
Network connection failed.
5
If the connection test passes, press [OK].
D Note
• If the connection test passes, you are ready
to use BD-Live™, DLNA home media
server or network update function, using
the Internet without making any additional
settings.
• If the connection test fails, you may need to
check your router settings and make sure
the physical connection is secure. If you
need the MAC address of this unit to
complete your router settings you can view
it on the "Network Status" screen (refer to
page 41).
EN
"Network
"Network"
Connection"
• When connecting this unit directly to a
modem for the first time or connecting it to
a modem which was previously connected
to any other network device (e.g. a router,
PC, etc.), you may have to power cycle the
modem to reset the settings on the modem.
Auto
Select "Auto" to set the network setting
automatically.
1
Follow steps 1 to 3 in "Connection Test" on
page 39.
2
Use [K / L] to select "Start", then press
[OK].
3
Use [K / L] to select "Auto", then press
[OK].
• The unit will start the connection test
automatically and the test result will
appear right after the test finishes.
4
Select "End" to activate the network
settings and set the network connection
automatically.
Manual
In the following cases, select "Manual" to set
each setting as necessary.
- When connection test failed with the setting
of "Auto".
- When instructed by your Internet service
provider to make specific settings in
accordance with your network
environment.
1
Follow steps 1 to 2 in "Auto" on page 39.
2
Use [K / L] to select "Manual", then press
[OK].
3
Use [K / L] to select "IP Address", then
press [OK].
39
Advertisement
Table of Contents
