Siemens SENTRON PAC2200CLP Product Manual page 72

Commissioning
6.3 Parameterizing the device
Write access to the device settings can be prevented by means of a password.
After the password has been entered once for the device, it is not requested again while the
device is still at the "Settings" level.
Password protection prevents the following actions:
• Changing of device settings, including password
• Changing and deletion of values
• Deletion of data and memory content
• Resetting to factory settings
Reading out of measured values and memory content is possible without restriction when
password protection is active.
"Reset" parameter
Selection
FACTORY SETTINGS
COMMUNICATION
PARAMETERS
Confirmation of the
reset
Note
The reset must be confirmed by pressing "Execute...". The device reset is not performed
otherwise.
70
Range
All the device settings, with the exception of the com-
munication parameters, are reset to the as-delivered
condition. No data relevant to statutory calibration
regulations (e.g. register values for active energy, load
profile values and logbook entries) is deleted.
No:
• Not active
Yes:
• Active
All communication settings are reset to the as-
delivered condition.
No:
• Not active
Yes:
• Active
Confirmation of the reset
Factory setting
No
No
0000
Equipment Manual, 06/2021, L1V30820585B-02
PAC2200CLP