Required Tools; Preparing Demounting; Demounting - Bosch Rexroth AGEV1-48404-AA/HM/L01H01-XC Operating Instructions Manual

Have sufficiently dimensioned collecting containers, non-linting cloth and medium-
binding materials ready in order to collect or bind leaking hydraulic fluid.

11.1 Required tools

When working in the potentially explosive area, only use tools that are suitable for
the relevant area.

11.2 Preparing demounting

1. Decommission the entire system as described in the general instructions for the
machine or system.
2. Depressurize the hydraulic system according to the instructions of the machine or
system manufacturer.

11.3 Demounting

Proceed as follows to demount the manifold block:
1. Observe the safety instructions as for mounting.
2.
Make sure that the hydraulic system is depressurized.
3. Check whether the manifold block has cooled down sufficiently so that it can be
demounted in a risk-free manner.
4. Disconnect the system from the power supply.
NOTICE! Spilled or discharged hydraulic fluid!
Environmental pollution and contamination of the groundwater!
▶ When draining the hydraulic fluid, always place a catch pan under the manifold
block.
▶ Observe the information in the safety data sheet for the hydraulic fluid and the
instructions provided by the system manufacturer.
5. Loosen the lines and collect the escaping hydraulic fluid in the collector provided
for this purpose.
6. Remove the manifold block. If necessary, use suitable lifting gear for this.
7. Drain the manifold block completely.
8. Plug all openings.
▶ While performing these working steps make sure that no dirt enters the openings.
RE 62272-B/03.19, Manifold block type AGEV1-48404-AA/HM/L01H01-XC, Bosch Rexroth AG
Demounting and replacement 31/40