Storing The Manifold Block - Bosch Rexroth AGEV1-48404-AA/HM/L01H01-XC Operating Instructions Manual

22/40 Transport and storage
Bosch Rexroth AG, Manifold block type AGEV1-48404-AA/HM/L01H01-XC, RE 62272-B/03.19

6.2 Storing the manifold block

Hydraulic components are delivered in an unobjectionable state.
Improper storage can be detrimental to the hydraulic product.
Unless specified otherwise on the installation drawing, adhere to a storage
temperature -10 ℃ to +50 ℃.
Hydraulic components can be stored for up to 6 months under the following
conditions:
▶ Do not store the hydraulic component outdoors but in a well ventilated room.
Avoid intense light.
▶ Protect the hydraulic component against humidity, particularly ground humidity.
Store the hydraulic component on a shelf or on a pallet.
▶ Manifold blocks can be very heavy. In this connection observe the admissible
load-bearing capacities of your storage system.
▶ Store the hydraulic component in its original packaging or an equivalent
packaging in order to protect it from dust and dirt.
▶ All connections at the manifold block have to be closed with plug elements.
▶ After the transport packaging was opened, it must be closed properly again for
storage. Use the original packaging for storage.
▶ Do not remove the covers from the hydraulic ports on the hydraulic block before
it is mounted.
In case of storage of more than six months or in case sea transport is necessary,
please consult Bosch Rexroth.
After expiry of the maximum storage time, we recommend having the manifold
block checked by your competent Rexroth service.