Rice Lake Load Ranger Quick Start Manual

Load Ranger Wheel Weigh Pads
Quick Start Guide
This document provides the procedures necessary to quickly setup the Load Ranger Wheel Weigh Pads and pair them with the
Ai-1 Indicator to take weight readings.
Wheel Weigh Pad Configuration
1. Press to power on the indicator then press
2. Press three times.  displays.
to enter the Serial menu.  displays.
3. Press
4. Press to enter the ID settings.
5. Press or
pad ID number.
The first Pad ID number must be 01 and the remaining pad ID numbers must increment in ascending numeric order.
Example: 01, 02, 03, etc.
6. Press to confirm.
7. Press to enter the Bluetooth Initialization menu.  displays.
8. Press to confirm.  displays followed by . displays.
9. Press twice.  displays.
10. Press to confirm.  briefly displays and all the changed parameters are saved.
11. Repeat steps for all wheel weigh pads in the system.
February 22, 2021
DATA
NUM
NUM
Figure 1. Wheel Weigh Pad Display
to increase or decrease the selected digit and press
displays.

SET SET
DIAG
MODE
during startup.  displays.
to move between the digits to enter the
PN 189611 Rev B