Toyota IS300h Manual page 278

1. SPEECH COMMAND SYSTEM OPERATION
INFORMATION
A USB memory or iPod must be con-

nected to enable track searching and
playback. (P.220, 225)
When a USB memory or iPod is con-

nected, recognition data is created so
tracks can be searched using speech
commands.
Recognition data is updated under the

following conditions:
• When the USB memory or iPod data
has changed.
• When the voice recognition lan-
guage is changed. (P.73)
While the recognition data is being

created or being updated, a track
search cannot be performed using a
speech command.
When "Play music" is dimmed in the

"Shortcuts" screen, it is not possible
to search for a track using a speech
command. In this situation, reduce the
amount of music data in the USB
memory or iPod and update the rec-
ognition data to enable searching by
speech command.
278
IS300h/250_Navi_EE
SPEECH COMMAND
EXAMPLE: CALL NAME
1
Press the talk switch.
 "Call <name>" is displayed in the
"Shortcuts" screen.
 When "Call <name>" on the "Short-
cuts" screen is dimmed, the contact's
speech command recognition cannot be
used. Check the Bluetooth
and if the contacts have been trans-
ferred to the navigation system.
2
Say or select a registered contact
name.
 In the same manner as it is displayed on
the screen, "Call <name>", after saying
"Call" say the name of a contact.
For example: "Call", "John Smith"
 Short or abbreviated names in the con-
tact list may not be recognized. Change
names in the contact list to full names.
 Sometimes a voice recognition result
confirmation screen will be displayed.
After confirming the result, say "Dial".
 When the system recognizes multiple
names from the contact list, a name
candidate list will be displayed on the
screen. If the desired name is not dis-
played on the top of the screen, say the
number of the name from the candidate
list to select a name from the candidate
list.
®
connection