Haivision Makito Air v2.3 Quick Start Manual

Makito Air
This Quick Start Guide summarizes the basic steps required to install and configure the Makito Air Ruggedized
HD/SD H.264 Video Encoder (single chassis, as shown below) to stream to your compatible decoding device.
Please refer to the Makito User's Guide or the online help (available from the Web Interface) for detailed
information.

Installing the Makito Air

1. Unpack the box and visually inspect the package contents for any evidence of shipping damage. [See Impor-
tant Notice for list of contents.]
2. Fasten the Makito Air to a flat surface (such as an equipment bay or rack) using the four (4) threaded
mounting holes (#10-32 screws).
3. Customers are responsible for assembling their own cables. Please refer to
for connector pinouts.
CAUTION Special care must be taken when wiring the supply. This unit is not protected against polarity
reversal, and if it occurs, the unit will be damaged (servicing will be required). The cabling must be done
in such a way as to maintain the safety, electrical and environmental integrity of the product.
4. Connect the DC input power cable to the power input [J10] at the rear of the unit.
5. Connect the chassis ground wire to the ground lug at the rear of the unit.
-230
HVS-ID-QS-MAIR , Issue 01
™
v2.3 Quick Start Guide
Chassis Ground
Power Input
Makito Air Rear Panel
HVS-ID-QS-MAIR-230, Issue 01
"Connector Mapping" on page 5
Page 1 of 5