Control Technology 2500 Series Installation And Operation Manual page 2

This manual is published by Control Technology Inc. (CTI) 5734 Middlebrook Pike,
Knoxville, TN 37921. This manual contains references to brand and product names which
are trade names, trademarks, and/or registered trademarks of Control Technology Inc.
®
Siemens , SIMATIC
Other references to brand and product names are trade names, trademarks, and/or
registered trademarks of their respective holders.
Every effort has been made to ensure the accuracy of this document; however, errors do
occasionally occur. CTI provides this document on an "as is" basis and assumes no
responsibility for direct or consequential damages resulting from the use of this document.
This document is provided without express or implied warranty of any kind, including but not
limited to the warranties of merchantability or fitness for a particular purpose. This
document and the products it references are subject to change without notice. If you have a
comment or discover an error, please call us toll-free at 1-800-537-8398 or email us at
sales@controltechnology.com.
Revision Date
1.0 4/15/2014
1.1 1/6/2020
1.2 1/11/2021
Copyright© 2021 Control Technology Inc.
All rights reserved.
® ®
, and Series 505 , and 505
DOCUMENT DISCLAIMER STATEMENT
REVISION HISTORY
Description
Initial Release
Clarified reference from Offset Scaling to Scaling. Corrected
Figure 26 and 27 Reference.
Corrected errors in Section 1.9. Scaling Enabled and Disabled
reference were incorrect. Default Shipping Configuration was
incorrect. Correct configuration was Scaling Enabled.
Removed Table in Section 1.6
®
are registered trademarks of Siemens AG.