Takara Belmont BRAMU Installation Manual

Be sure to store this manual in a secure location together with the operation manual as it describes
items that must be understood by the customer.

Installation Procedures

1. Move the chair to the installation location.
●Move the chair by holding the skid.
(Carrying the chair by the upper
part is dangerous because the base
could come off and drop.)
●When the chair is still on the skid,
move the chair to the edge of the skid
as shown in the figure on the right, tilt
the chair and skid, and pull out the
skid. Removing the skid without tilting
it can result in the skid interfering with
the mechanisms on the underside of
the base, causing an abnormal noise to
be emitted when the chair is rotated.
●Remove the chair from the skid. Raise
the chair off the floor by holding the
metal plate under the foot switch.
Move the chair by holding the base
and body, or the metal plate of the foot
switches. Do not hold the chair by the
skirt.
•Hold onto the base, foot switches
CAUTION
•Make sure not to apply excessive
and backrest, or the body when
performing procedures such as
transporting, installing the rubber
wheels to, or positioning the chair.
When holding the chair, be careful
not to wrinkle or dirty the leather,
and that the base does not come off.
force that could damage the chair
even when holding by the parts
shown in the figure on the right.
Installation Manual
Skid
Foot switches Base
Backrest
Foot
switches
Hold the parts shown in gray while working. Hold the parts shown in gray while working.
1
Bang!
Skid
Body
Base
2017.02
BOOK NO. 1E01TUAE BOOK NO. 1E01TUAE
Skirt
Body