Table of Contents
Advertisement
T. Thermostat Battery Replacement
This thermostat is powered by two "AA" Alkaline batteries.
The batteries should be replaced AT LEAST once per
year to ensure reliable operation or sooner if the LO BATT
appears on the display screen. The batteries are located
on the back of the thermostat's circuit board. The front
portion of the thermostat can be removed from the back
half by using the tabs on the top edge of the thermostat
housing (Figure 16.1).
Figure 16.1
When installing new batteries, it is recommended using
only brand new "AA" size alkaline batteries. Please verify
the polarity markings shown in the battery compartment
before adding batteries to the compartment. When finished,
line up the front of the thermostat to the base, and firmly
press together to securely latch the front and back halves
together properly.
BATTERY GRAPHIC:
Anytime time the batteries are physically present in
the thermostat, there will be a visual indicator showing
the life of the battery. This will appear on the display
screen (Figures 16.2 and 16.3).
Figure 16.2 - Full battery icon
Figure 16.3 - Low battery icon
16
CONNECT THERMOSTAT WIRES TO APPLIANCE:
There is a 4 screw terminal block located on the back
lower left corner of the stove directly above the power
cord inlet. The center 2 screws are for the thermostat
wires (Figure 16.4).
Figure 16.4
Shock hazard.
•
Do NOT remove grounding prong
from plug.
•
Plug directly into properly grounded 3
prong receptacle.
•
Route cord away from appliance.
•
Do NOT route cord under or in front
of appliance.
7019-802H
Junction Box, Front
LEFT SIDE
Terminal block.
Center 2 screws for
thermostat wires
CAUTION
04/21
Advertisement
Table of Contents
