Table of Contents
Advertisement
D. Igniter
PART NUMBER: SRV7000-462
1. Shut down the appliance by turning down the
thermostat and let the appliance completely cool down.
After the appliance has cooled down, unplug it and
remove the ash drawer.
2. The wire leads to the igniter are connected to the wire
harness with 1/4 inch (6mm) male / female spade
connectors. These wires will pull forward approximately
4 to 5 inches (102mm to 127mm) through the grommet
at the back of the ash drawer chamber. Disconnect
the spade connections and remove the igniter from
the chamber. Loose the thumb screw and slide igniter
out (Figure 27.1).
3. Install new igniter into the chamber and tighten the
thumb screw. Re-connect the wires to the 2 leads with
the spade connectors.
4. Push excess wire leads back through the grommet, one
wire at a time, to take-up the 4 to 5 inches (102mm to
107mm) previously pulled out. This will keep the wires
out of the way of the ash drawer. Double check that
the igniter wires are clear of any movement, i.e. ash
drawer, fire pot cleaning rod, cleaning slide plates, etc.
5. Re-install the ash drawer and then re-install the side
panel and re-connect the power.
Igniter Bracket
Thumb Screw
Figure 27.1
CAUTION
Shock Risk.
•
Do NOT remove grounding prong
from plug.
•
Plug directly into properly grounded 3
prong receptacle.
•
Route cord away from appliance.
•
Do NOT route cord under or in front
of appliance.
27
E. Glass
1. Open the face and remove door from the appliance by
lifting door off of hinge points and lay on a flat surface
face down.
2. Using a flat head screwdriver pry out rope from door
and clean any silicone around the screw heads.
3. Using a Phillips head screwdriver remove the seven
screws and set aside.
4. Remove glass retainers and set aside.
5. Remove old glass assembly and discard.
6. Lay new glass assembly in place.
7. Add glass retainers.
8. Using a Phillips head screwdriver fasten glass retainers
to door assembly ensure glass assembly is centered
within the frames.
9. Add rope into crevice as shown below in Figure 27.2.
10. Re-install door and close face to appliance.
Igniter
Figure 27.2
7019-802H
PART NUMBER: SRV7021-032
Screws
Glass
Assembly
Door Assembly
WARNING
Handle glass with Care.
•
Glass is 5mm thick high temperature heat-
resistant ceramic glass.
•
DO NOT REPLACE with any
other material.
•
Alternate material may shatter and
cause injury.
Rope
Glass Retainers
04/21
Advertisement
Table of Contents
