Table of Contents
Advertisement
5
Service Parts Replacement
A. Blowers
1. Combustion Blower
PART NUMBER: 812-4400
a. Remove panel set and disconnect flue.
b. Pull appliance out onto the hearth.
c. Remove right access panel and then slide out
right side panel of appliance, held in place
with 2 screws, to expose the exhaust blower
(Figure 25.1).
d. Disconnect the white and blue wires from the
blower. Remove blower mounting screws (not
housing bolts), Figure 25.2, from blower housing
and remove blower. The replacement blower
is shipped with a housing. If you do not need
the housing, discard it. If you do need to the
replace the housing you will also need to replace
the gasket.
e. Re-install in reverse order.
Figure 25.1
Housing Bolts
Blue Wire
White Wires
Figure 25.2
25
Exhaust Blower
Blower Mounting
Screws
7019-802H
2. Convection Blower
PART NUMBER: 812-4900
a. The blower is located at the bottom rear of the
insert. If an outside air kit is also installed, you
will first need to remove the outside air flange
by removing the 2 screws using a Phillips head
screwdriver. You do not need to remove the flex
pipe from the flange.
b. Remove panel set and disconnect flue.
c. Pull appliance out onto the hearth.
d. Remove left access panel and then slide out left
side panel of appliance to expose the convection
blower. Loosen wing nut on the vacuum switch and
remove vacuum switch to allow room to remove
the blower (Figure 25.3).
e. Disconnect the wires from the blower. The wires
coming from the wiring harness are purple & white
and the wires from the blower are black.
f.
The blower is held in place with a magnet. A
wing nut and plate are installed at the factory for
shipping purposes only. This can be removed once
the appliance is installed. Lift up blower from the
magnet and remove.
g. Re-install in reverse order.
Blower
locator plate
Magnet attached to
bottom of blower
Figure 25.3
Wing nut & plate
installed for shipping
purposes only.
Discard
04/21
Advertisement
Table of Contents
