Sharp LC-R60HDU Service Manual page 15

[Using the buttons on the remote controller]
(1) On the test mode screen, move the cursor (yellow), using the ("',"") buttons, to select the number of the
replaced lamp (LAMP No.1 or No.2).
(2) Press the "ENTER" button twice.
Now the lamp timer has been reset. If the two lamps have been replaced, take the same steps for each.
LAMP No.1
LAMP No.2
LAMP USE RESULT
NOW
1
2
3
TOTAL
Test mode initial screen
4. Checking the reset.
Make sure the timer of the replaced lamp is reset at 00000H.
If not, take the timer resetting procedure over again.
5. Quitting the service mode
To quit the service mode, take the same steps as for calling the service mode.
Before clearing the service mode, be sure to bring the service mode initial screen first with the "BACK" button.
[Using the buttons on the remote controller]
(1) Press the "BACK" button once.
(2) Press the "MUTE" button twice.
(3) Press the "VOL +" button once.
(4) Press the "VOL –" button once.
(5) Press the "ENTER" button twice.
(6) Press the "MENU" button once.
Now the service mode is cleared, displaying ADJ OUT onscreen.
ADJ OUT
TEST
NG
OK
No.1 No.2
08000H 08000H
00000H 00000H
00000H 00000H
00000H 00000H
08000H
15
LC-R60HDU